Testing communication between Lizzox Pure Flood and myDatanet server (mobile network connection)
- Within the desired customer, create a new site/application for operation of the Lizzox Pure Flood on the myDatanet server (see Creating the site).
- Configure the created
site/application according to your requirements (see Site configuration).
The following configurations should be set if you also want to thest the recording of the measurement values at the same time:
- Check or enter the mounting height (see Sub Level settings) of the sensor modules in the relevant input fields.
- Ensure that the parameters "Offset" and "trimming" are set to 0 (see Universal channel)
- Connect the sensor (see Connecting the sensors).
- Trigger a connection using the solenoid switch (see Solenoid switch). In doing so, the configuration of the site is also transferred to the Lizzox Pure Flood .
- Wait until it is indicated in the list of sites/applications that the device is
connected to the server (rotating arrows).
The Lizzox Pure Flood is connected to the server for a very short time. You can therefore check if the time stamp of the last connection (under the green status symbol) has been updated.
- Wait until a couple of measurement values have been recorded. The waiting time depends on the configured record interval (see Device settings )
- Trigger a transmission again to transfer the recorded measurement values to the myDatanet server.
- Click on the "Direct Report" symbol in the list of sites/applications to display the
data saved on the myDatanet server.
- Check whether all of the data up to the point of the synchronisation is present and plausible. Pay particular attention to the main level reading and the signal strength of the mobile network.
The following step is only necessary if you also want to test the measurement
value acquisition at this time:
The following steps are only necessary if you also
want to test the measurement value acquisition and the data transmission at this
time.
