Setpoint module
This module uses the setpoints for the outputs entered via the configuration interface of the myDatanet server.
The following table specifies the relevant parameters for the module:
| Configuration section | Mode | Parameter | Explanation |
|---|---|---|---|
| Output channels -> Basis | Off | --- | -- |
| Ext. warmup time1) | |||
| Digital | Setpoint | Setpoint (on/off) that should be issued | |
| Freq | Setpoint | The setpoint multiplied by the factor equals the frequency in Hertz. The result of the multiplication must not exceed 1000 Hz. | |
| Pulse | Setpoint | The setpoint multiplied by the factor equals the pulse/min. The result of the multiplication must not exceed 320 pulses/min. |
1) In "Ext. warmup time" mode, the output is actuated by the device itself to activate the sensor supply for the measurement (see Output channels).
