Scale module (outputs)
This module rescales the setpoint (e.g. mm) into the desired physical size (e.g. frequency) for the output.
The following table specifies the relevant parameters for the module:
| Configuration section | Mode | Parameter | Explanation |
|---|---|---|---|
| Output channels | Off | --- | --- |
| Ext. warmup time1) | |||
| Digital | Invert | Inverts the level issued on the device | |
| Voltage2) | Selection of the output voltage | ||
| Freq3) | Factor | The setpoint multiplied by the factor equals the frequency in Hertz. The result of the multiplication must not exceed 1000 Hz. | |
| Pulse3) | Factor | The setpoint multiplied by the factor equals the pulse/min. The result of the multiplication must not exceed 320 pulses/min. |
1) In "Ext. warmup time" mode, the output is actuated by the device itself to activate the sensor supply for the measurement (see Output channels).
2) Selection of the output voltage is only possible for the switchable sensor supply VOUT.
3) These modes are only available for the isolated switch contact (NO, CC).
