Scale module (outputs)
For the output channels, this module rescales the setpoint (e.g. "on") into the desired signal level on the output (e.g. "low"). Hence, it enables inverting the setpoint.
For the modbus output channels, this module rescales the setpoint (e.g. mm) into the desired raw value to be written to the register.
The following table specifies the relevant parameters for the module:
| Configuration section | Mode | Parameter | Explanation |
|---|---|---|---|
| Output channels | off | --- | --- |
| digital | Invert | Inverts the level issued on the device | |
| Modbus output channels -> Basic | Scale "off" | --- | --- |
| Scale "on" | 0 % Modbus | Start of the output range in the unit of the modbus server (i.e. the raw value to be written in the modbus server) | |
| 100 % Modbus | End of the output range in the unit of the modbus server (i.e. the raw value to be written in the modbus server) | ||
| 0 % | Start of the output range in the measurement unit | ||
| 100 % | End of the output range in the measurement unit |
