Control module
The control module determines the setpoints for the outputs.
The following table specifies the relevant parameters for the module:
| Configuration section | Mode | Parameter | Explanation |
|---|---|---|---|
| Output channels | Off | --- | --- |
| Digital | --- | --- | |
| Measurement channels ->Trigger | Digital Cnt.Day Cnt.Intrvl. 4-20 mA 0-20 mA 0-2 V 0-10 V | D1 | If this checkbox has been selected, the setpoint on the output channel "RELAY1" of the data logger is controlled using trigger. In doing so, the setpoint entered via the interface is ignored. |
| D2 | If this checkbox has been selected, the setpoint on the output channel "RELAY2" of the data logger is controlled using the trigger. In doing so, the setpoint entered via the interface is ignored. | ||
| Internal channels -> Trigger | --- | D1 | If this checkbox has been selected, the setpoint on the output channel "RELAY1" of the data logger is controlled using trigger. In doing so, the setpoint entered via the interface is ignored. |
| D2 | If this checkbox has been selected, the setpoint on the output channel "RELAY2" of the data logger is controlled using the trigger. In doing so, the setpoint entered via the interface is ignored. |
