DeviceConfigDeviceConfig
General
The DeviceConfig configuration program can be downloaded free of charge from the following website:
www.microtronics.com/deviceconfig
The tool is used for configuration, maintenance, fault analysis and synchronisation purposes. It is compatible with all myDatanet devices equipped with a USB interface or local radio interface. For devices equipped with a mobile network modem, the function of the local interface (USB and local radio interface) may be restricted depending on the current lifecycle state. Some of the functions described below may therefore not be fully available.
The requirements regarding configuration and maintenance vary depending on the type of device. To ensure simple and intuitive operation, the user interface of the DeviceConfig therefore automatically adjusts to the relevant device that is connected. In addition to the standard functions, the tool also supports device-specific processes (e.g. calibration, zero point adjustment).
The DeviceConfig enables you to complete the following tasks:
- Synchronisation of measurement data and configuration between device and server (specifically for devices without mobile network modem)
- Basic configuration of the device (e.g. measurement and transmission cycle)
- Read out and analysis of the device log
- Calibration, trimming and zero point adjustment (special knowledge and password required)
- Update the firmware (only if the lifecycle state is set to " " (not set) or "preprovisioned")
Prerequisites
| Interfaces | 1x USB |
| Operating system | Windows 10
Windows 11 |
| Internet connection | Recommended |
| Required disk space | approx. 50 MB |
