Determining the measurement value at the mA input

The module chain described in the following is started in a configurable measurement interval and executed once. The measurement interval is independent from the record interval and can be adjusted via the parameter "measurement interval" (see Device settings ). It is used to monitor the conditions under which a "Smart action" is triggered. It is then the currently valid measurement value generated in the measurement interval that is recorded. The measurements executed since the last recording are not consolidated (e.g. average determination). The interval for the recordings can be selected via the "Record interval" parameter (see Device settings ). The "Smart actions" can however be used to switch to an alternative record interval (see Edit Smart Action).

1	Filter to compensate short-term signal fluctuations (see Filter module). The filter module is run through several times during the determination of a measured value.	4	Adds the values entered via the configuration parameters "trimming" and "offset" to the measurement value (see Trim/Offset module)
2	Monitoring of the measurement range limits (see Overflow module)	5	Monitoring of the conditions under which a "Smart Action" is triggered (see Smart Action module)
3	Rescaling from the raw value to the measurement value (see Scale module)	6	As the record interval can be selected differently from the non-changable measurement interval, the measurement values are not recorded every time a measurement takes place (see Record module).