Trim/Offset module

An offset for the measurement value, if required, can be taken into consideration with the help of this module. It also enables the zero point to be adjusted without having to change the already set offset again. The "Trimming" parameter value and the "Offset" parameter value are added to the initial value of the scale module (see Scale module). This means that a negative prefix must be set for the "Trimming" parameter (see Additional explanation on the zero point adjustment and installation height of the sensor) if the scaled measurement value should be reduced during the zero point adjustment.

The following table specifies the relevant parameters for the module:

0-20 mA
4-20 mA