Installing the myDatalogEASY IoT ATEX

Important:
  • Ensure installation is completed correctly.
  • Comply with existing legal and/or operational directives.
  • Improper handling can cause injuries and/or damage to the devices.
  • The myDatalogEASY IoT ATEX must not be operated in the field with the lid open.
  • The pressure compensation must be protected against contamination.
  • The myDatalogEASY IoT ATEX is not approved for use in sewers.
  • When using metal mounting components, these must be integrated into the grounding concept in a suitable manner.

The installation site must be selected according to specific criteria. The following conditions must be avoided in any case:

  • Direct sunlight
  • Direct weather exposure (rain, snow, etc.)
  • Objects that radiate intense heat (maximum ambient temperature: -20...+50 °C )
  • Objects with a strong electromagnetic field (frequency converter or similar)
  • Corrosive chemicals or gases
  • Mechanical impacts
  • Direct installation on paths or roads
  • Vibrations
  • Radioactive emissions

Tip: Leave sufficient space at the upper end to install the antenna. The space required depends on the antenna used. Approx. 15 cm of space must be left beneath the device for the cable connections. Further information regarding the installation dimensions can be found in the relevant sub-chapter.