Installing the myDataconC3 MBM
Important:
- Ensure installation is completed correctly.
- Comply with existing legal and/or operational directives.
- Improper handling can cause injuries and/or damage to the devices.
- The myDataconC3 MBM is not approved for use in sewers.
- The myDataconC3 MBM is not suitable for outdoor use.
Note: It is recommended that all metal mounting fixtures be
properly earthed.
The installation site must be selected according to specific criteria. The following conditions must be avoided in any case:
- Direct sunlight
- Direct weather exposure (rain, snow, etc.)
- Objects that radiate intense heat (maximum ambient temperature: -20...+60 °C)
- Objects with a strong electromagnetic field (frequency converter or similar)
- Corrosive chemicals or gases
- Mechanical impacts
- Direct installation on paths or roads
- Vibrations
- Radioactive emissions
Tip: Approx. 2-5 cm of space must be left above and
below the device for the cable connections. The antenna connections are located at the front
of the device. The space required depends on the antennas used. Further information
regarding the installation dimensions can be found in the relevant sub-chapter.
