Setpoint module
This module uses the setpoints for the outputs entered via the configuration interface of the myDatanet server.
The following table specifies the relevant parameters for the module:
| Configuration section | Mode | Parameter | Explanation |
|---|---|---|---|
| Output channels | off | --- | -- |
| Digital | Setpoint | Setpoint (on/off) that should be issued | |
| Output channels - analogue | off | --- | -- |
0-20 mA 4-20 mA 0-24 V | Setpoint | Output value in the measurement unit | |
| Output channels - digital | off | --- | -- |
| Digital | Setpoint | Setpoint (on/off) that should be issued |
