Storage of the product

To store the Lizzox Pure Flood , deactivate the measurement system via the title bar of the configuration section "Measurement system" (see Measurement system). Then trigger a transmission using the solenoid switch (see Solenoid switch) or use the "OnSite Companion" smartphone app, to synchronize the altered configuration between device and server (see Synchronisation with the myDatanet server). This way any data that has not yet been transferred to the myDatanet server until this point in time is transmitted. The data transmission and measurement are then deactivated. The local radio interface used for communication between Lizzox Pure Flood and smartphone app is also deactivated. If the device is in "Deactivated" mode, the local radio interface can be reactivated for approximately 10 minutes by briefly pressing the solenoid switch (for approx. 1 sec.). As soon as the mobile connection has been terminated (indicated by the status LED going out) or the "OnSite Companion" smartphone app reports that the synchronisation process is complete, the sensor cables can be removed. Store the Lizzox Pure Flood in the original packaging.

Important: When storing the Lizzox Pure Flood , ensure that the MDN Magnet is not positioned in the vicinity of the solenoid switch, as this could accidentally trigger transmissions.

Deactivating the measurement system puts the Lizzox Pure Flood in an energy-saving mode. However, it may still occur that the rechargeable buffer battery is fully discharged if the device is stored in the dark for very long periods. The configuration and the most recently recorded data will be retained in any case. To resume operation of the Lizzox Pure Flood , activate the measurement system via the title bar of the configuration section "Measurement system". Then trigger a transmission using the solenoid switch or use the "OnSite Companion" smartphone app to synchronize device and server. The Lizzox Pure Flood will then resumes operation according to the configuration.