Storage of the product

To store the Jellox Pulse , deactivate the measurement system via the title bar of the configuration section "Measurement system" (see Measurement system). Then trigger a transmission using the reed switch (see Reed switch) to synchronise the altered configuration between device and server. This way any data that has not yet been transferred to the myDatanet server at this point in time is also transmitted. The data transmission and measurement are then deactivated. The sensor cable or, for the variant with external antenna connector (Type key D022‑4Z001200D05), the antenna can be removed as soon as the mobile network connection has been disconnected - indicated by "transport mode" being shown on the display (see Display). If necessary, you can reactivate the display by shortly (approx. 1 sec.) pressing the reed switch (see Reed switch). Store the Jellox Pulse in the original packaging.

When deactivating the measurement system, the Jellox Pulse is placed in a very in a very energy-saving mode. However, it may still occur that the batteries are fully discharged if the device is stored for very long periods. The configuration and the most recently recorded data are thereby retained in any case. To resume operation of the Jellox Pulse , activate the measurement system via the title bar of the configuration section "Measurement system". Then trigger a transmission using the reed switch to synchronise device and server. The Jellox Pulse will then resume operation according to the configuration.