Wall mounting

1. Drill the four holes with a diameter of 10 mm and a minimum depth of 60 mm in accordance with the dimensions specified in figure Wall mounting step 1 for the wall plugs (10x50) that are included in the scope of supply of the mounting kit.
2. Insert a wall plug (included in the scope of supply) into each of the four drilled holes before you screw the mounting bracket (1) to the wall.
3. Connect the Multi band rod antenna with connection cable 250 mm to the antenna connector of the Jellox Node .
   Tip: Depending on the installation situation, it may be more practical to connect the Multi band rod antenna with connection cable 250 mm after inserting the Jellox Node into the mounting bracket.

   

   Connecting the mobile network antenna

   1

   Antenna connector

   2

   Multi band rod antenna with connection cable 250 mm

4. Insert the Jellox Node into the mounting bracket bottom first. Tilt the Jellox Node forward (i.e. away from the wall) to position the top of the Jellox Node underneath the upper brace of the mounting bracket.

   

   Inserting the Jellox Node

   1	Jellox Node	3	Mounting bracket
   2	Upper brace of the mounting bracket	4	Connection cable 7-pins for sensors 2,8 m

5. Press the top of the Jellox Node towards the wall until the lug of the protective armour is fully engaged in the upper brace of the mounting bracket.

   

   Locking the Jellox Node in place

   1

   Lug of the protective armour

   2

   Upper brace of the mounting bracket

6. Insert the Multi band rod antenna with connection cable 250 mm into the designated slot in the upper brace of the mounting bracket.

   Inserting antanna step 1

   Inserting antenna step 2

   1

   Multi band rod antenna with connection cable 250 mm

   2

   Antenna slot

The following step is only required if you want to add an anti-tamper seal.
7. Pass the sealing wire through the opening in the upper brace of the mounting bracket and through the retaining lug of the protective armour. Form a closed loop and insert both ends of the sealing wire through the seal. Ensure that the sealing wire is tight but not under tension. Secure the seal by pressing it together with sealing pliers. If necessary, document the process in accordance with internal company guidelines.

   

   Caution: Cut the wire ends cleanly to prevent injury.

    

   

   Installing the security seal

   1	Opening for security seal or anti-theft device	3	Lug of the protective armour
   2	Security seal