Setpoint module
This module uses the setpoints for the output channels and the modbus output channels entered via the configuration interface of the myDatanet server.
The following table specifies the relevant parameters for the module:
| Configuration section | Mode | Parameter | Explanation |
|---|---|---|---|
| Output channels | off | --- | -- |
| Ext. warmup time1) | |||
| Digital | Setpoint | Setpoint (on/off) that should be issued | |
| Freq | Setpoint | The setpoint multiplied by the factor equals the frequency in Hertz. The result of the multiplication must not exceed 1000 Hz. | |
| Pulse | Setpoint | The setpoint multiplied by the factor equals the pulse/min. The result of the multiplication must not exceed 320 pulses/min. | |
| Modbus output channels -> Basic | --- | Setpoint
| Output value in the measurement unit |
1) In "Ext. warmup time" mode, the output is actuated by the device itself to activate the sensor supply for the measurement (see Output channels).
