Compatible sensors

Microtronics Engineering GmbH is constantly testing various sensors with mA output or Modbus server interface (RS485) for compatibility with the Lizzox Pure Flood . If your sensor is not on the list, please contact us at support@microtronics.com. We will then check whether your sensor can be used together with the Lizzox Pure Flood and determine the recommended configuration settings.

Note: The specifications for sensor supply and warm-up time are recommendations. The required warm-up time depends on the operative conditions and must be determined by the user in the respective application and installation situation. If the current consumption of the sensor exceeds the capacity of the sensor supply of the Lizzox Pure Flood , the correct function can be established if necessary by increasing the sensor supply (within the system limits). The information in the following table is without guarantee and Microtronics Engineering GmbH assumes no responsibility if an installation set up based on the information contained in the table does not function as expected.

Sensors with mA output
Manufacturer Designation Type Sensor supply / warm-up time Scaling (0/4mA, 20mA)1)
VEGA Vegapuls C21 Radar sensor 15 V / 15 sec. 0...20 m (4-20 mA)

1) This is the factory default setting. If the user has changed the sensor configuration, the actual settings may differ.

Sensors with Modbus server interface
Manufacturer Designation Type Sensor supply / warm-up time Server address / Modbus address / Function code 1)
KELLER Pressure AG PAA-33X Piezoresistive pressure transmitters (absolute pressure) 15 V / 1 sec. 1 / 256 / FC03
PAA-36XW Piezoresistive level probe (absolut pressure) 15 V / 1 sec. 1 / 256 / FC03
VEGA Vegapuls C21 Radar sensor 15 V / 15 sec. 246 / 1304 / FC04

1) This is the factory default setting. If the user has changed the sensor configuration, the actual settings may differ.